Jump to content
twvette

Ok to turn wastegate setting off?

Recommended Posts

Good morning! There is no benefit to adjust that. It should not be an issue unless you were to build too much boost. I have never experimented with that setting.

 

 

Thank you!

Share this post


Link to post
Share on other sites

I tried turning it off and carefully played around to make sure not building too much boost. It did not seem to do nothing in terms of the data log that I could tell compared to it on Stock setting log for similar full throttle test. I did hold about 1 PSI more boost but I think this was more due to conditions than anything really changing. Boost initially spiked to 35 PSI and even thought this should be the limit of the sensor I don't think it really never went beyond this based on the log profile and then settled in at about 29-30 PSI. I would like to see it hold a bit more so will likely do adjustable boost elbow and boost or wastegate fooler.

Share this post


Link to post
Share on other sites

Been running with disabled wastegate for a while. Highest I've gotten is about 32 psi.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×